How to Replace Snapped Garage Door Springs?

Garage Door Spring Replacement

How to Replace Snapped Garage Door Springs?

If you want to loam how to replace snapped garage door springs then you came to the right place.Atlanta Garage Door Experts are here to explain to you how to accomplish just that and to make sure that you do a good job and without hurting yourself in the process.

Garage door spring repair might sound like something simple enough that almost anybody could do it but as always appearances can be deceiving and we need to proceed with caution whenever we try to replace a snapped garage door spring. So call experts if you garage door spring snapped.

This procedure it is very dangerous and can result in serious injuries and even death if all the safety measures are not respected. Before you even start working on it, you need to wear proper gear for security reasons: gloves, safety glasses, working boots, fit clothing, and no jewelry.

This operation require certain physical strength, ability and agility. It is very important that you understand and follow instructions because this is a very serious matter. If you have any doubts, it is better to consult a garage door professional. If you need to replace springs in garage then you should cantat to our experts.

If you garage door is equipped with two springs, it is wise to replace them both at the same time because if one spring is broken, that means the other spring is also close to the end of its life cycle. While your door is disassembled, it is recommended to replace the cables as well

To do the job you need the following tools: ladder, locking pliers, sockets & ratchet 3/8″ – 7/16″ – 1/2″ – 9/16″, C clamps, winding bars, file.

Step 1. In order to prevent any activation by accident, you need to unplug and remove the garage door opener from the door.

Step 2. ou need to shut and lock the door and put a tight clamp on the track above any roller.

Step 3. Unwind the existing torsion springs. if your door has two torsion springs, you need to unwind the spring that is not broken. While unwinding it, you need to count the number of 1/4 turns removed because you’ll have to use the same number 01 1/4 turns when winding in the new spring.

Step 4. Take out the cables and cable drums. Put your ladder on each side of the cable drums and get their screws loose. Next, take out the cable from the drum and move the cable drum away from the head plate.

Step 5. Take out the snapped torsion spring.

Step 6. Inspect and replace the cable with a new one if needed.

Step 7. Place the new spring on the shaft, put the cable drum back into the shaft as well and put the shaft back into the head plate. Repeat this operation for the other spring. Don’t tie the screws just yet. Put your ladder in the middle of the door and bolt the springs to center bearing plate.

Step 8. Set the cables.

Step 9. Wind up the springs.

Step 10. Test the door.

Step 11. Put back the garage door opener, plug it into a power outlet and test it again.

As you can easily tell, a simple garage door repair is not so simple after all If you ever need help, Atlanta Garage Door Experts are more than happy to help you by offering the following garage door services: garage door installation, broken garage door spring repair, garage door opener repair.

Internet Special Offers